1.     Introduction

2.     Outline of extraordinary vessel treatment

3.     How to use

4.     About IP (germanium diode with a conversion switch)

5.     Direction of IP

6.     Acupuncture points locations

7.     How to use it without a needle, with rivet

1.     Introduction

In ancient times, it was said that acupuncture starts with buxie and end with buxie (consumption and elimination) Great forefathers struggled to make the best of buxie, and thus various special skills and different schools of acupuncture were born. They are advanced skills that are difficult for beginners to reach.

The fundamentals of acupuncture are circulation of the meridian system. Facilitating the circulation of the medial system is called tai chitreatment. It balances mind and body with advancing the concept of meridian system circulation to move vital energy and blood.

NAS tai chiextraordinary vessel treatment evaluates meridian system energy and analyzes the number with PC software to draw up the guidelines for treatment.

Even beginners can make effect of advanced treatment with NAS tai chiextraordinary vessel treatment.

2.     Outline of extraordinary vessel treatment

The basic way of NAS tai chi extraordinary vessel and the main channel treatment is using vessels as a spillway to drain too much qi (electricity and ion) in the main channel. IP is able to move qi that overflow. When IP is used, it deals with not only the eight extraordinary vessels but also xiangu-hegu for yangming and shaoyin and jueyin’s tongli or wuming-taichong. In this treatment, you decide thecombination of acupuncture points according to the analysis that the PC software provides. Buxie is done with IP to improve meridian system circulation.

3.     How to use

Prepare stainless needles. The IP ion pump that Dr. Manaka invented is used for buxie. (On meridian system, a weak current passes on average 500na. It’s not myoelectric.)

NAS measuringinstrument has a measuring instrument tester that measures a point between two points near jin point to avoid other electrical interferences. Type the number it shows you on the PC software to make it calculate and put a short needle on the acupuncture point that the program chose. Then use IP with a conversion switch there and make ion on meridian system move from a sick meridian to another meridian. Put a needle on the same acupuncture points on the healthy side of body to give the right and left pressure (advocated by Dr. Manaka) to improve effect. You can give your patients advanced treatment thorough choosing right acupuncture points.

4　is time, we will use IP that Dr. Manaka invented. When examining the electricity of the main meridian, you measure a current nano-ampere on the hypothesis that the qi flowing on the main meridians as a circulation of ion at NAS taiji extraordinary vessel treatment. Put a probe for a tester on each jin point and ascertain the truth of the capacity of energy on meridians according to current of nano-ampere.

You can suppose that jin points that have a big amount of current are sick meridians. This treatment is so simple that electric energy that has nowhere to go move to another side to adjust the balance.

For example, the right jin point is highest in jin points of lever meridians you put the probe, decide yin heel vessel as a main vessel and the right lieqian that corresponds to the right zhaohai of conception vessel as a sub vessel. Ion pumping brings out homeostasis effect and adjusts the extra electric energy on the mail meridian naturally. The meridians that are adjusted this time are kidney, pericardium, san jiao, gall bladder and liver. To improve the effect, do ion pumping on another side as well and switch IP to the opposite direction. The meridians that are adjusted this time are lung, large intestine, stomach, spleen, heart, small intestine, urinary bladder and kidney.

1.     For example, when a currAbout IP (germanium diode with a conversion switch)

In thent (800na) flows on jin point of the right kidney meridian the most, put IP to make electric energy that fills in meridians move to the right lieqian from the right zhaohai. (One side with a sticker should be put on the lower stream and the switch should be laid on the same side.) On another side, knot IP to make electric energy move from the left lieqian to zhaohai. (One side with a sticker should be put on the lower stream and the switch should be laid on the same side, and it should be knotted to cross top and bottom.) Shake meridians to improve the circulation and adjust it using the differences between top and bottom, and right and left. This method is recommended by Dr. Manaka and it is very effective at a clinical situation. It’s so comfortable that most patients fall asleep within 5 minutes.

In addition, Dr. Irie who established Irie FT School said that most patients fall asleep within 5 minutes if IP works, so it doesn’t work if a patient opens their eyes. In this case, choose acupuncture points again and adjust the direction of IP. (As for sleepiness, it is thought that sympathetic nerves are suppressed and serotonin was secreted, then it changes melatonin and then people get sleepy.)

5.     Property and direction of IP

In principle, IP with a conversion switch should be laid from the main acupuncture point to sub acupuncture point. (A current mainly flow from main point to sub point.)

NAS style IP with a conversion switch uses germanium diode. The property of germanium is that weak electric current (about 300na) can flow both directions. (It depends on the room temperature.)

The direction of IP is an important factor of treatment, but there are some currents that flow opposite direction even if the direction of IP (germanium diode), so you can expect good effect if you take a time and you don’t need to be too nervous about it. But of course, you can expect good sharp effect in a short time if the direction of IP is correct.

The seesaw effect makes the function stronger at a symmetry treatment. You can adjust it with putting a bronze rivet on a jin point as well. In this case, the direction of wiring is opposite when it is skin wiring, so please refer to the attached instruction. (Put a drop of silver ion water on a point of contact between skin and bronze then.)